Bosch SMV2ITX23E - Setting the Softening System; Special Salt

deSoftening system
ABC
4. Press repeatedly until the
appropriate water hardness level is
set.
ABC
A notice:Set your device to the
determined water hardness level.
→ "Setting the softening system",
page 24
If the water hardness level is 0 - 6 °dH,
you can avoid using special salt for
dishwashers and switch off the
softening system.
→ "Switch off the softening system",
page 25
0, 1, 2 or 3 LEDs light up
accordingly.
→ "Overview of the water
hardness settings", page 23
Level 1 is set at the factory (LED
A → Page 16 ).
5.To save the settings,
Press for 3 seconds.
10.2 Setting the softening
system
10.3 Special salt
Set the device to the water hardness
level.
1.Determine the water hardness level
and the appropriate setting value.
→ "Overview of the water
hardness settings", page 23
You can soften water with special
salt.
Pour in special salt
If the special salt refill indicator lights
up, fill special salt into the special salt
storage container immediately before
starting the program. The consumption
of special salt depends on the degree of
water hardness. The higher the water
hardness, the higher the consumption
of special salt.
2. press.
3.To open the device settings,
3 seconds
press.
a flashes.
DANGER!
Cleaner can damage the softening
system.
▶ Only fill the storage container of
the softening system with special
salt for dishwashers.
Special salt for dishwashers can
damage the washing container
through corrosion.
▶ So that overflowed special salt is
rinsed out of the washing container,
the special salt immediately
24