cleanserde
Overflowing rinse aid can lead to
excessive foam formation during
the rinse cycle.
11.3 Switch off the rinse aid
system
4.Close the lid of the rinse aid
reservoir.
If the rinse aid refill indicator bothers
you, for example if you use combined
detergents with a rinse aid
component, you can switch off the
rinse aid system.
aThe lid clicks into place audibly.
11.2 Adjust the amount of rinse
aid added
Tip:The function of the rinse aid is
limited with combined detergents. If
you use rinse aid, you will usually
achieve better results.
If streaks or water stains remain on
the dishes, change the amount of rinse
aid added.
1. press.
1. press.
2.To open the device settings,
3 seconds
press.
2.To open the device settings,
3 seconds
press.
a flashes.
a flashes.
3. press repeatedly until
3. press repeatedly until
flashes.
flashes.
4. Press repeatedly until the
appropriate amount of rinse aid
has been added.
4. Press repeatedly until there is no LED
→
Page 16
lights up (level 0).
5.To save the settings,
Press for 3 seconds.
ABC
aThe rinse aid system is switched off
switches on and the rinse aid refill
indicator is deactivated.
R1some 2 cleaners
0, 1, 2 or 3 LEDs light up
accordingly.
Level 2 is set at the factory (LED
A and LED B →
Page 16
).
– A low setting adds less rinse aid
to the wash cycle and reduces
streaks on the dishes.
– A higher level adds more rinse
aid to the rinse cycle, reduces
water stains and produces a
better drying result.
cleanser
12.1 Suitable cleaners
Only use cleaner that is suitable for
dishwashers. Both solo cleaners and
combined cleaners are suitable.
To achieve optimal rinsing and drying
results, use solo cleaners in
conjunction with the separate
application of special salt →
Page 24
and rinse aid →
Page 26
.
Modern, powerful cleaners
predominantly use a low-alkaline
formula with enzymes.
5.To save the settings,
Press seconds.3 ek
27
To Next Page
Loading...
