Softening systemde
Pour into the special salt storage
container before starting the program.
10.4 Switch off the softening
system
If the special salt refill indicator
bothers you, e.g. B. if you use
combined cleaners with salt
substitutes, you can switch off the
special salt refill indicator.
1.Unscrew and remove the lid from
the special salt storage container.
2.When using for the first time: Fill
the storage container completely
with water.
Notice
To avoid damage to the device, only
switch off the softening system in the
following cases: ¡The water hardness
level is maximum
times 21 °dH and you use a
combined cleaner with salt
substitutes. According to the
manufacturer, you can usually only
use combined cleaners with salt
substitutes up to a water hardness
of 21 °dH without adding special
salt.
¡The water hardness level is 0 -
6 °dH. You can do without special
salt.
3. Note:Only use special salt for
dishwashers.
Do not use salt tablets. Do not
use table salt.
Pour the special salt into the storage
container.
1. press.
2.To open the device settings,
3 seconds
press.
Fill the storage container completely
with special salt. The water in the
storage container is displaced and
drains away.
a flashes.
3. Press repeatedly until no LED
lights up (level 0).
→
"Overview of the water
hardness settings", page 23
4.Place the lid on the storage
container and screw it on.
4.To save the settings,
Press for 3 seconds.
aThe softening system is equipped
switches on and the salt refill
indicator is deactivated.
25
To Next Page
Loading...
