deBasic operation
– Do not place any small parts in
the tab collecting tray and do not
block it with dishes so as not to
block the lid of the detergent
compartment.
G1
comprehensive service
4 basic
service
Basic operation
14.1 Switch on the device
▶ press.
The Eco 50° program is preset.
The Eco 50° program is a
particularly environmentally friendly
program and is ideal for normally
soiled dishes. It is the most efficient
program in terms of the
combination of energy consumption
and water consumption for this type
of tableware and proves conformity
with the EU Ecodesign Regulation. If
you do not operate the device for 10
minutes, the device switches off
automatically.
13.3 Clear out dishes
WARNING
Risk of injury!
Hot dishes can cause burns to the skin.
Hot dishes are sensitive to impact and
can break and cause injuries.
▶ After the end of the program, let
the dishes cool down a little and
then remove them.
14.2 Setting the program
To adapt the washing cycle to how
dirty the dishes are, set a suitable
program.
▶ Press the program button
repeatedly until the appropriate
program is set.
1.To avoid water droplets falling on
the dishes, empty the dishes from
bottom to top.
aThe program is set and
the LED flashes.
2.Check the washing container and
accessories for dirt and clean if
necessary.
→
"Cleaning and care",
page 39
14.3 Setting additional
functions
To complement the selected washing
program, you can set additional
functions.
A notice:The additional functions that
can be activated depend on the
program selected.
32
To Next Page
Loading...
