deTroubleshooting
Disturbance Cause and troubleshooting
Leftover food on dishes
dishes.
▶ Adjust the upper dish rack to the same height on
the left and right.
→
"Upper dish rack", page 21
Removable streaks
are located on glasses,
glasses with a metallic
appearance
and cutlery.
The amount of rinse aid added is set too high.
▶ Set the rinse aid system to a lower level.
→
""Setting the amount of rinse aid added", page 27
No rinse aid is filled.
▶ Add rinse aid.
→
"Filling with rinse aid", page 26
Detergent residues are present in the rinse program section.
The lid of the detergent compartment was blocked by pieces
of crockery and did not open completely.
1.Place dishes in the upper dish rack so that the tab
drip tray is not blocked by dishes.
→
"Putting away the dishes", page 31
The dishes are blocking the cleaner lid.
2.Do not place dishes or air fresheners in the tab drip
tray.
Dishes have been pre-cleaned too much. The sensors
determine a weak program flow. Stubborn dirt
sometimes cannot be removed.
▶ Only remove large food residues and do not pre-
wash the dishes.
Traces of rust on surfaces
plug.
Cutlery is not sufficiently rust-resistant. Knife blades
are often more severely affected.
▶ Use rust-resistant dishes.
Cutlery also rusts if rusting parts are washed with it.
▶ Do not wash rusty parts.
Salt content in the rinse water is too high.
1.Remove any spilled special salt from the rinsing
container.
2.Tighten the cap of the special salt container tightly.
There are cleaning residues
in the detergent
chamber or in the
tab collecting tray.
Spray arms were blocked by crockery and the
detergent was not rinsed out.
▶ Make sure the spray arms are not blocked and
can rotate freely.
48
To Next Page
Loading...
