Bosch SRU53E05AU - Repair; Installing the Module

815_58300000120057_ara_en_d.doc – 25.05.11 Seite 30 von 60
6 REPAIR
6.1 Installing the module
The position of the module in the support plate depends on the brand.
There are two options:
If the module is not installed in the correct position,
the optical fibres in the panel may break off.
6.1.1 At the bottom of the support plate (Bosch, Siemens, Neff)
The module is attached at the indicated points.
6.1.2 A the top of the support plate (regional brands, e.g.
Constructa, Balay, Pitsos...)
The module is attached at the indicated points.