815_58300000120057_ara_en_d.doc – 25.05.11 Seite 31 von 60
6.2 Replacing the Aqua Stop valve
► Open the housing
► Disconnect the inlet hose
► Cut through the electric connecting cables
► Strip the insulation off the cable ends
► Push the shrink-fit hose over the cable
► Connect electric cables to the insulating sleeves (1.)
►
After fitting, warm the connectors until the shrinkage process occurs
and the hot-melt adhesive comes out of the ends of the connectors
(2).
► Push the shrink-fit hose over the connectors and also warm until
the shrinkage process is complete (3)
To Next Page
Loading...
