815_58300000120057_ara_en_d.doc – 25.05.11 Seite 38 von 60
6.7 Removing and installing hinge
6.7.1 Removal
► Unscrew outside door, base panel, angle strip and side panels.
► Detach tension cord (E) from hinge lever (B)
► Unscrew hinge lever (B) from the inner door
► Disengage bearing bush (C) and remove hinge lever (B)
► Unscrew hinge plate (A) from the container frame
► Unscrew fastening screw from the hinge plate towards the base
pan, as well as the adjusting screw if fitted
► Unscrew hinge plate (A) from the frame
► Pull up the hinge plate (A) and remove
► Remove the spring clamp (D);
Two-piece hinge bearing bush:
Open the bearing bush (C) by disengaging the spacer (G) with
a screwdriver (see sketch)
One-piece hinge bearing bush:
Open the bearing bush (C) by bending up the clips (H) with
a screwdriver. When the bearing bush (C) is removed, it must
be renewed.
A
Hinge plate
E
Tension cord
B
Hinge lever
F
Tension spring
C
Bearing bush
G
Spacer
D
Spring clamp
H
Clips
To Next Page
Loading...
