815_58300000120057_ara_en_d.doc – 25.05.11 Seite 34 von 60
1.1 Axial flow sensor
6.4.3 Removal
► Remove the left side wall
► Remove securing clip (1)
► Pull the flow sensor (2) from the water inlet
► Loosen the hose clip (3)
► Remove supply hose (4).
► Remove connector plug from reed switch.
6.4.4 Installation
► Connect the supply hose (4) to the flow sensor (2)
► Attach the hose clip (3)
► Connect the reed switch connector plug
► Attach the flow sensor (2) to the water inlet and secure it with
the securing clip (1)
► Install the left side wall
To Next Page
