815_58300000120057_ara_en_d.doc – 25.05.11 Seite 42 von 60
6.10 Replacing the door seal
The new seal must be adjusted prior to installation.
Adjusting the seal
► Prior to insertion, ensure that the seal lip is pointing
towards the middle of the rinsing tank, otherwise
there will be leaks in the area of the door
► adjust the length of the seal to the circumference of the container.
► cut the ends of the seal at an angle 45°.
► place the seal on the base of the container. (Splash-proof
protection for the lower corners).
► Press in the seal evenly and without any kinks
To Next Page
Loading...
