Bosch TriTech - Walk Test LED

Commercial Series TriTech and TriTech AM
detectors
Configuration | en 31
Bosch Security Systems B.V.
Installation manual
2022.01 | 01 | F.01U.401.708
RLED
ON ON
OFF OFF
RLED
RLED
ON
OFF
RLED
TR TRNCNC
T
RLED
T
Tritech AM
ON
ON
OFF
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
ON
OFF
ON
ON
OFF
LOW
HIGH
LOW
HIGH
7.3 Walk test LED
Before you begin the walk test, review the walk test LED indicator statuses. Refer to Walk test
LED.
At the beginning of the test, with no motion in the protection area, the LED should be OFF. If
you observe LED activity without movement, check for disturbances affecting the microwave
or PIR technologies.
The walk test LED indicates the detector's operational status.
2 min
During the warm-up period (after providing power to the
device), the LED flashes continuously until the device is
ready for use.
During walk test, the LED indicates PIR and microwave
activity activity and also a motion alarm condition (dual
alarm).