Bosch VIA - Page 13

How to use the remote control (VIA-RC)
How to insert batteries
@ Use your fingers to open the battery holder as shown. Capper paamecropremrepyngrr ae
E 4
@Insert
the
battery
into
the
battery
case.
Be
careful
Attention
seating
or
exploding,
Please
note
the
following
points,
(Also
caretlly ead the precautions for bates) elnsert
not
to
mark
the
wrong
battery
as
shown
the
batteries
correctly
withthe
positive
and
negative
ends
as
indicated
on
the
battery
case:
Please. *Do
Inside, @Return the battery holder. not mix new and used batteries. «Some dry balteries have
different voltages even if they have the same shape. kinds
Do not mix batteries of different types. If the
product will not be used for a long time (more than a month), remove the
batteries to prevent battery fluid from leaking, If battery leaks, thoroughly
Xie te td inside the case before inearing a new batay
Remote control operating range
a
‘*if
you
use
it
near
devices
that
emit
infrared
rays
or
use
other
remote
control
devices
that use infrared
rays, it may malfunction.
Conversely,
if you
Use this remote
control
when using other equipment
that operates
using
Infrared
rays, that equipment
may maffunction,
‘if direct suniight oF strong light rom a fluorescent lamp hits the sensor ight receiving area,
you
may
not
be
able
fo
operate
the
remote
control
If
this
happens,
change
the
location
of the unt or move it away from fluorescent igh.
Attention Ea eanasantanosauenenmianaaaana
ro een rc cord ae sar gh ng
The effect will become worse. If these symptoms occur,
replace the batteries in the remote control.
How to install’the main unit
—
This
unit
is
equipped
with
speakers
using
a
newly
developed
Virtual
imaging
array
to
reproduce
a rich
To
take
full
advantage
of
this
characteristic
and
reproduce
a
spacious
sound,
we
recommend
installing
it
as
shown
in
the
illustration.
Try
to
find
the
optimal
distance
from
the
side
walls
and
rear
wall
while
actually
playing
the
sound.
/
Installation guidelines: Make the distance from the lefl and right walls to the projector equal
~ Leave a distance of about 30 to 50 cm between the back wall
and the device.
1