Bosch VIA - Before Recording

MD deck operation <MD recording>
before recording
@Attention
»)
When
"Din
Unlock"
appears:
IND /ecording is hol possible when using DC 5 - The digital recording selected with the AUX button is not connected
correctly. Please connect the sound source correctly
When "Protected" is displayed:
The sound source device is not turned on. Please turn on the power,
The MD is in a state to prevent accidental erasure. You can record
by sliding the MD's erase prevention knob to close the hole When "TOC Writing" is flashing
Since the recorded content is being recorded on the MD, do not unplug
When "Disc Full" is displayed: the power plug from the outlet or shake the unit, It may not be
ISI SIO PCE ON ING NED AORTeCON Ine EUNCE Eee mma recorded correctly. If you unplug the power plug immediately after
inetlongetneed te make) recom. on prepares new recemting MD recording, the recorded content will not be recorded,
If "Cannot Copy" is displayed:
Py pay This machine complies with the Serial Copy Management System
1am trying to digitally record a sound source that cannot be
Digitally recorded MDs cannot be further digitally recorded
digitally recorded, Try making the input analog.
Convenient functions when recording
It
comes
with
useful
features
such
as:
@
-Automatic
digital
level
adjustment
(only
when
recording
CDs).
ae : Also, this function can be turned on/off.
eAuto mark (digital recording only) ‘ )
The recording level is automatically adjusted to match the recording level of
‘Automatically assigra vack numbers
the sng recorded on the CD. Even i the recording levels ofthe CDs are dfferent,
Auto
REC
ready
you
can
record
without
discrepancies
in
the
recording
level
depending
on
the
CD.
During analog recording, if there is 6 seconds of silence between songs, the
recorder automatically enters the REC ready state, Recording will start automatically * How to tum on/off
when the signal Is Input again 1. While the CD is stopped, press the 1 19 REC button to enter the
Music synchronization 2. Each time you press the 3 edit button on the remote control,
If a signal is input while “Ready?” is displayed on the display, "D-ALC: ON" and "D-ALC: OFF" will appear alternately on
recording will start automatically. the display. 3. When the desired setting is displayed, press the
© mset button.
°CD text copy
When you record a song from a CD with text, the song title is
automatically copied
to the MD. *Disc titles are not automatically copied.
To record for a long time
This unit supports recording and playback of LP2 and LP4. LP2 mode allows up to 160 minutes of stereo recording, up to 320 minutes of stereo recording
There are two types of LP4 modes. To select LP2 and LP4 © 20 Press the MDLP button. Also, switch between LP2 and
LPs during REC pause.
Regarding recording source and recording method (digital or analog)
GPa
rt
eaes
Be
‘
~
Digital
recording
To
See
ee
ee
eee
ee
+
Analog
recording
Copying prohibited CD... « + Analog recording TO OPT ih od + y+ + + Digital recording
Mixing recording of other sources and microphones analogrecording _—_—microphone
+ analog recording
tuner a sue 4 2 4 + 4 + + Analog recording
38