TroubleshootingNL
Malfunction Cause and Troubleshooting
Washing water is not
pumped out.
Drain pipe or water drain hose is clogged.
▶ Clean the drain pipe and the water drain hose.
Drain pipe or water drain hose is kinked or
pinched.
▶ Make sure that the drain pipe and the water
drain hose are not kinked or pinched.
Drain pump is clogged.
▶
→
"Cleaning the drain pump", page 42
Water drain hose is connected too high.
▶ Install the water drain hose at a maximum height of 1
meter.
Detergent dosage is too high.
▶ Immediate measure: mix a tablespoon of fabric softener
with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
▶ Reduce the amount of detergent for the next wash
with an equal load.
Unauthorized extension mounted on the water drain
hose.
▶ Remove any unauthorized extensions from the
water drain hose.
→
"Connecting the device", page 15
Pump cover is not fully screwed in.
▶ Make sure that the pump cover is screwed into the
device as far as it will go. The pump cover handle
must be vertical.
→
"Cleaning the drain pump", page 43
No water flows into
the device. The
detergent was not
washed in.
was not pressed.
▶ Press .
Strainer in the water supply is clogged.
▶ Clean the strainer in the water supply.
Water tap is closed.
▶ Open the water tap.
Water supply hose is kinked or pinched.
▶ Make sure that the water supply hose is not
kinked or pinched.
49
To Next Page
Loading...
