NLTroubleshooting
Malfunction Cause and Troubleshooting
Start several times
with centrifugation.
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
▶ No error - no action required.
Remark:When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
The water is not
visible in the drum
bar.
The water is below visible range.
▶ No error - no action required.
▶ Do not fill the device with additional water during
operation.
In the compartment
there is residual water.
Bet in compartment
▶
→
"Cleaning the detergent drawer", Page
41
is hidden.
Vibration and movement
of the appliance
during the spin
run.
The appliance is not leveled properly.
▶
→
"Adjusting the device", Page 16
Device feet are not fixed.
▶ Secure the device feet.
→
"Adjusting the device", Page 16
Transport protections have not been removed.
▶
→
"Remove transport locks", page 14
.
Drum is spinning, er
no water flows into
the appliance.
Load recognition is active.
▶ No error, no action necessary.
Remark:The load detection can take up to 2 minutes.
strong foam
ming.
Detergent dosage is too high.
▶ Immediate measure: mix a tablespoon of fabric softener
with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
▶ Reduce the amount of detergent for the next wash
with an equal load.
High spin speed
rental is not
reached.
Low spin speed is set.
▶ Set a higher spin speed for the next wash.
is activated.
▶ Select a suitable program for the type of fabric.
Unbalance control system compensates for
imbalance through reduced spin speed.
▶ Redistribute the laundry in the drum.
50
To Next Page
Loading...
