13
infoak@boschert.de
www.boschert.de
Mattenstraße 1
79541 Lörrach-Hauingen
Tel.: +49 (0) 7621 - 95 93 0
Fax: +49 (0) 7621 - 55 18 4
Changes reserved Version: 01/ 2004
!
Safety
2.22 Electrical energy
Use only original fuses with specified strength of current. In case of malfunctioning of the
electric energy supply, switch off the machine immediately.
Work on the electrical component may only be done
according to the applicable electrical codes by an electrician or an
instructed person under the supervision of an electrician.
The electrical equipment of a machine is to be regularly inspected and examined.
Deficiencies such as loose connections or scorched parts must be immediately repaired.
Check if power to the machine is cut off before inspection, maintenance, and repair work is
carried out. First test whether the parts which have been cut off are free of voltage, then
ground and short circuit them and isolate adjacent current-carrying parts.
If work is required on parts under power, have a second person available to operate the
emergency shutdown or main switch in the case of an emergency. Isolate the working area
with a red and white security chain and a sign of warning. Use only tools with proper
insulation.
2.23 Noise
All sound protection installations of the machine must be in their protective position during
operation. Wear necessary personal ear protection.
3.1 Principles
The machine has been built in accordance with current and recognized safety regulations.
Nevertheless, careless use of this machine could result in injury.
This machine should be used only for purposes for which it was designed. All safety devices
and guards must be kept in place and used at all times.
The end user of this machine has sole responsibility to provide proper safety devices and
equipment to safeguard operators and to comply with all government and industry standards.
Any malfunctions which could impair safety must be reported immediately to supervisory
personnel.
3 General comments
To Next Page
Loading...