21
infoak@boschert.de
www.boschert.de
Mattenstraße 1
79541 Lörrach-Hauingen
Tel.: +49 (0) 7621 - 95 93 0
Fax: +49 (0) 7621 - 55 18 4
Changes reserved Version: 01/ 2004
Description
When switching on the control, the mode of operation SET-UP is always set first. The mode
of operation can be changed according to the following diagram:
SET-UP:
The machine can be moved to the lower limit by pressing the down arrow button on the
operator panel. The LED above the button is illuminated if the machine is moving
downwards. The machine can be moved to the upper limit by pressing the upwards arrow
button on the operator panel. The LED above the key is illuminated if the machine is moving
upwards.
CONTINUOUS STROKE:
After the start via holding down the foot switch, the material is continually processed by
complete downward and upward strokes until the foot is taken off the switch.
SINGLE STROKE:
Only one complete downward and upward stroke can be done by pressing the foot switch.
For a new start the foot has to be taken off the foot switch.
SET-UP CONTINUOUS STROKE SINGLE STROKE
To Next Page
Loading...
