m
* 5osB recommends using a ql~4ity surge suppressor on all electronics equipment.
Voltage variations and spikes can damage electronic components in any system. A quality
suppressor can eliminate the vast majority of failures attributed to surges and may be pw
chased at an electronics store.
Checking
the
connections
Check all connections from the receiver
to
the powered Acoustimass® module and from the
module to the cube speakers (Figure 5 and Figure
6).
Make sure the cube speakers are con-
nected
to
the proper terminals according
to
their position
in
your room. Check that the wires
are
connected
to
your surroundreceiver
in
phase (+ to + and
~
to+
Correct wiring problems
before you plug your receiver
in
and turn it on.
Connecting
the
Acoustimass
module
to
po
wet·
) N@te: Bose®
recommends
using
a
quality
surge
suppressor
on
all
electronics equipment.
Voltage variations
and
spikes
can
damage
electronic
components
in
any
system. A
quality
suppressor
can
eliminato
thc.;
vast
majority
of
fai/uros
attributed
to
surg(9S
and
may
be
pur-
chased
at
an
electronics store.
After you have checked
all
system connections, plug the power cord of the powered Acousti-
mass module into
an
AC (mains) receptacle. Your Acoustimass speaker system will turn
on
and off automatically as it receives a signal from your surround receiver.
12
To Next Page
Loading...
Need help?
General
