22 - Installation Guide
Installation
pro.Bose.com
Dual Mono Select Mode
Line-level sources can be connected using RCA jacks or Euroblock connectors. The system sums the two
RCA jacks for each input to mono.
Dual Mono Select Mode source routing is fixed, as shown below.
Auxiliary output can be set up to track OUTPUT 1 or constant audio from INPUT 1.
This mode supports the use of one user interface for each output channel using a volume control with
A/B select user interface.
Note: With use of a user interface, the chassis output gain knob is disabled.
For further detail, see “Mode user interface requirements” on page 28.
Figure 11. Dual Mono Select Mode with volume control user interfaces
To Next Page
Loading...
