17
Installation
pro.Bose.com
5.
Mount the loudspeaker on the wall plate. Slide the fin of the speaker bracket into the wall bracket and install the
M8 x 25 mm pivot screw, and then the M6 x 25 mm pitch locking screw.
M6 X 25 mm
M8 X 25 mm
6. Set the pitch and yaw of the loudspeaker.
To set the pitch: Loosen the M8 x 25 mm screw, remove the M6 x 25 mm screw, change the angle and re-insert the
screw. Tighten both screws.
To set the yaw: loosen both screws screw, change the angle and tighten both screws.
M6 X 25 mm
M8 X 25 mm
±60°
0° to –45°
7. Using an M8 x 16 mm screw, attach the safety cable to the speaker. Make sure the safety cable is attached to the wall
independent of the wall plate.
CSB-5A suspension bracket kit (for indoor use only)
M8 x 1.25 x 12 mm (3)
(3)
To Next Page
Loading...
