Design Guide - 27
CSD Properties and Operation
3. The next step is to identify which MSA12X device block represents which physical array on the network. To
do this, double-click the device block and open the MSA12X control panel, and press the ‘Identify’ button at
the bottom. An LED at the back of the physical array flushes and you can identify the device block.
If you cannot access the back of the array to see the LED, another option is to push ‘Advanced…’ button and
use the Audio Check mode.
With the ‘Internal’ option, an internal signal generator feeds a 1 kHz signal to the array and the array can be
identified by that sound.
To Next Page
Loading...
