28 - Design Guide
CSD Properties and Operation
4. Once you identify the array, rename the device, such as ‘Left-Array, ‘Right-Array. This is the device name
used for Dante® routing later. The device name can be the same as the Array name already defined in
Modeler, but they can be dierent.
You can rename the device by right-clicking the device icon in the Project View.
Note: The device name should follow the rule for Dante device labeling: Legal characters are A-Z, a-z, 0-9, and
‘-’ (dash or hyphen). Device labels must begin with A-Z (or a-z).
To Next Page
Loading...
