System Setup
16 - English
Step 8: Checking for sound
1. Power on your TV and cable/satellite box (if needed).
2. Press
on the Solo system remote.
Make sure the system status indicator is solid green.
System status
indicator
3. Check if sound is coming from the Solo system.
If you do not hear sound from the Solo system see “Troubleshooting” on page
29.
Tip: At this time, you may consider setting your Solo system to automatically wake
from standby whenever it receives a sound signal. See “Using auto-wake” on
page 21.
Step 9: Adjusting the bass
The bass control knob on the back of the system allows you to change the
bass level output of the system.
Turn the bass control knob right to increase the bass, left to decrease the bass.
Note: For optimal sound quality for dialog-only programming, such as news and talk
shows, see “Using dialog mode” on page 27 (Solo 15) and page 28 (Solo 10).
To Next Page
Loading...
