System Setup
18 - English
Connecting a TV headphones output to the system
If your TV only has a headphones connector, you need a dual RCA-to-3.5 mm stereo
cable (not provided) to connect to the Solo 15/10 system.
1. Insert the stereo plug into the TV headphones connector.
2. Insert the white plug into the L connector on the Solo system.
3. Insert the red plug into the R connector on the Solo system.
4. Ensure your TV speakers are on. Refer to your TV’s Owner’s Guide for more
information.
5. To ensure optimal volume control from your system, set your TV’s volume to
75 percent of maximum; then set the volume level of your system using the
remote control.
Audio IN Solo 15/10 system
Audio OUT
TV headphones
or other variable
audio output
Dual RCA-to-3.5 mm
stereo cable
(not provided)
To Next Page
Loading...
