Bose SoundTouch SA-4

30 - English
Appendix B: Wall mounting the
SoundTouch™ SA-4 amplifier
Vertical
orientation
Connector
panel is
facing left.
Horizontal
orientation
Connector panel
is facing up.
Follow these instructions to wall mount your SoundTouch
TM
SA-4 amplifier.
Install either vertically with the connector panel facing left, or horizontally
with the connector panel facing up.
1. Remove rubber feet from the SA-4 amplifier. Use these holes to mount the
amplifier on the wall.
2. To mark mounting hole locations, hold the SA-4 amplifier in position and mark
the wall through the holes in the housing.
3. Drill holes.
4. Insert and tighten screws (and anchors, if used).
Appendices