Boss MS-3 - Editing the Settings of a Patch: Basics; Basic Patch Editing Workflow

11
Editing the Settings of a Patch
Basic Operation
1. Recall the patch that you want to edit
(p. 10).
2. Press the [EDIT] button.
The eect chain screen appears.
3. Use the [1] knob to choose the eect
you’re going to edit.
You can press the [ON/OFF] button to turn
on/o the eect where the cursor is located
(shown highlighted).
Eects that are turned on are indicated with
icons. Eects that are turned o are indicated
with “
5
.”
For details on the parameter, refer to the
“Parameter Guide” (PDF le).
Icon Explanation
Choose from a variety of eect types.
You can also choose the same eect
for FX1 and FX2.
Choose from various types of
modulation eect.
You can also choose the same eect
for MOD1 and MOD2.
–
Turn loop eects on/o.
Choose from various types of delay.
Choose from various types of reverb.
Noise suppressor
Control the volume.
* This cannot be turned o.
Adjust the tonal character of
patches, and make other settings.
(PATCH LVL)
Specify the patch level (the volume
of the patch).
When the cursor is moved here, the
[3] knob adjusts this.
Specify how sound is output from
the OUTPUT jacks.
Refer to “Changing the CTL/ASSIGN/
MIDI Settings” (p. 12).
MEMO
If you’ve selected FX1, FX2, MOD1, MOD2, DLY,
or REV, you can use the [3] knob to choose its
eect type.
4. Press the [ENTER] button to enter the
edit screen.