5
Getting Ready
Top Panel
1
2
3
4
5
6
1
Display
The MS-3 shows various information here.
2
[1]–[3] knobs
Use these to select or edit the
values of parameters shown in
the screen.
[1] [2] [3]
* Refer to “Operation of the [1]–[3] Knobs” (p. 7).
3
On/O indicators
Show the status of each eect.
On: lit, O: unlit
* In MUTE & TUNER mode, these indicators
operate as TUNER indicators.
4
[ON/OFF] button
When editing, press this to turn the selected
eect on/o.
Lock function
In the play screen, long-press the [ON/OFF]
button for two seconds or more to turn the lock
function on, so that all buttons and the [1]–[3]
knobs are disabled. This lets you prevent the
settings from being changed inadvertently.
Long-press the button once again to turn the lock
function o.
[MENU] button
Press this to make system settings.
[EDIT] ([< PAGE] button
Press this to make patch settings.
5 In screens that show page tabs, this operates
as the [< PAGE] button to switch pages.
4
[EXIT] button
Press this to cancel an operation, or to return to
the previous screen.
[ENTER] ([PAGE >])button
Press this to conrm an operation.
5 In screens that show page tabs, this operates
as the [PAGE >] button to switch pages.
5 In the play screen, use this to switch the
display.
5
[MEMORY/MANUAL] switch
Switches between memory mode (indicator lit
blue) and manual mode (lit red).
* Hold down the switch for two seconds or
longer to enter MUTE & TUNER mode.
6
Number switch [1]–[4]
In memory mode, use these to select patches. In
manual mode, use these to operate the assigned
function.
When pressed simultaneously in
memory mode
* This does nothing in manual mode.
5 If you press [1] and [2] simultaneously, the
bank number goes down each time you press
the switches. (Bank down)
5 If you press [3] and [4] simultaneously, the
bank number goes up each time you press the
switches. (Bank up)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
