19
AUTOMATIC WATCHES
Standard 2-Hand and 3-Hand Models
Positions of the crown:
Position 1 - Normal position.
Crown pushed against the case.
Position 2 - Setting the TIME:
Rotate the crown in either direction.
To manually wind an automatic movement:
The motion of your arm during normal daily activities should
be sufficient to keep the movement of your automatic
timepiece wand. However, if you have not worn your watch
for a few days, and the watch has stopped, you will need to
wind it by hand before setting the time:
1. With the crown in position 1, turn the crown clockwise
approximately 20 revolutions.
2. Reset time following instructions above.
Small seconds hand
24 hours
A: Start/Stop
B: Intermediate time /
Reset to zero
To Next Page
Loading...
