-14-
MAINTENANCE CHECKLIST
Maintenance Benefit Procedure Service Interval
I
nspect trigger performance
E
nsure trigger system is in
p
roper working order
R
efer to Tool Operation
C
heck section in this manual
D
aily
Drain condensation from air
compressor tanks and air
filters (if present)
Prevents accumulation of
moisture that can impede
tool performance
Open drain cock on tanks
and air filters and drain all
condensate
Daily
C
lean magazine assembly
P
revents accumulation
of debris that could
c
ause a jam
B
low clean with
compressed air
D
aily
C
lean nose assembly
P
revents accumulation
of debris that could
cause a jam
B
low clean with
compressed air
D
aily
Ensure all fasteners remain
t
ight
Prevent loose parts Tighten all fasteners with
a
ppropriately sized hex
w
rench
Weekly
Replace no-mar tip Prevents marks in softwood
applications
Remove worn no-mar tip and
replace with a new tip (a spare tip
is located on the magazine)
25,000 Fasteners
Replace air fitting Maintains proper air flow to
engine for peak performance
Remove worn air fitting and
replace with new fitting
50,000 Fasteners
Replace piston/driver
assembly
Maintains consistent drive
quality
Refer to replacement part kit
instructions
150,000 Fasteners
Replace O-rings Maintains engine for peak
performance
Refer to replacement part kit
instructions
250,000 Fasteners
Replace bumper Maintains engine for peak
performance
Refer to replacement part kit
instructions
250,000 Fasteners
Replace headvalve Maintains engine for peak
performance
Refer to replacement part kit
instructions
250,000 Fasteners
Replace engine cylinder Maintains engine for peak
performance
Refer to replacement part kit
instructions
500,000 Fasteners
To Next Page
