Bostitch BT1855 - LOADING THE BT1855 & SX1838; Prevent Accidental Injuries During Loading

-7-
LOADING THE BT1855 & SX1838
E
YE PROTECTION
w
hich conforms to ANSI specifications and provides protection against
f
lying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and
others in the work area when connecting to air supply, loading, operating or servicing this
tool. Eye protection is required to guard against flying fasteners and debris, which could
c
ause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
e
quipment must conform to the requirements of the American National Standards Institute,
A
NSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded
s
pectacles and face shields alone do not provide adequate protection.
T
O PREVENT ACCIDENTAL INJURIES:
•
Never place a hand or any other part of the body in nail discharge area of tool while
the air supply is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
•
Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
•
Do not pull the trigger or depress the trip mechanism while loading the tool.
LOADING THE SX1838
LOADING THE BT1855
1. Depress magazine release button and pull back magazine.
2. Open magazine fully and turn tool sideways with discharge area pointed away from yourself and others.
Load staples in channel.
3. Push magazine forward until latch is engaged.
1. Depress magazine release button and pull back magazine.
2. Open magazine fully and turn tool sideways with discharge area pointed away from yourself and others.
Load brads in channel.
3. Push magazine forward until latch is engaged.
?180585RC_BT1855-SX1838_Tools_Man_AC:121037RevH_BTSLSX_Manual.qxd 2013/11/12 ? 午12:05 Page 7