12
MAINTENANCE CHECKLIST
Maintenance Benefit Procedure Service Interval
I
nspect trigger performance
E
nsure trigger system is in
p
roper working order
R
efer to Tool Operation
C
heck section in this manual
D
aily
Drain condensation from air
compressor tanks and air
filters (if present)
Prevents accumulation of
moisture that can impede tool
performance
Open drain cock on tanks
and air filters and drain all
condensate
Daily
Clean magazine assembly Prevents accumulation of
d
ebris that could cause a jam
Blow clean with compressed air Daily
Clean nose assembly Prevents accumulation of
debris that could cause a jam
Blow clean with compressed air Daily
Ensure all fasteners remain
t
ight
Prevent loose parts Tighten all fasteners with
a
ppropriately sized hex
wrench
Weekly
Check/clean air inlet air filter Maintains proper air flow to
engine for peak performance.
Remove end cap and use
compressed air blow gun to
blow filter clean. Replace filter
as required.
25,000 Fasteners, or monthly
- if used in dusty location
Replace no-mar tip Prevents marks in softwood
applications
Remove worn no-mar tip and
replace with a new tip (a spare tip
is located on the magazine)
25,000 Fasteners
Replace swivel air fitting Maintains proper air flow to
engine for peak performance
Remove worn swivel air fitting
and replace with new swivel
fitting
50,000 Fasteners
Replace piston/driver
assembly
Maintains consistent drive
quality
Refer to replacement part kit
instructions
150,000 Fasteners
Replace O-rings Maintains engine for peak
performance
Refer to replacement part kit
instructions
250,000 Fasteners
Replace bumper Maintains engine for peak
performance
Refer to replacement part kit
instructions
250,000 Fasteners
Replace headvalve Maintains engine for peak
performance
Refer to replacement part kit
instructions
250,000 Fasteners
Replace engine cylinder Maintains engine for peak
performance
Refer to replacement part kit
instructions
500,000 Fasteners
To Next Page
Loading...
