9.8 BLIND and HOME
[BLIND] temporarily removes a channel from a chase when it is playing, and allows
you to manually control that chase.
To switch to Blind mode:
1. Keep [BLIND] pressed and press the [FLASH] button associated with the
channel that is temporarily removed from the Chase.
2. To return to normal chase, keep [BLIND] pressed and press the respective
[FLASH] button.
9.9 PARK
When the device is in [CHNS
〈
〉
SCENES] mode, keep [PARK] pressed to switch between
‘Single’ and ‘Mix’ mode.
When the device is in ‘Double Preset’ mode, press [PARK] simultaneously together
with [MASTER B].
In ‘Single Preset’ mode, the current output can be recorded. Settings are made with
[MASTER B].
9.10 ADD/KILL
[ADD/KILL] changes the mode of the ‘Flash’ buttons. Normally, the ‘Flash’ buttons are
in ‘Add’ mode. Pressing [FLASH] does not deactivate a scene, different scenes can run
at the same time.
‘Kill’ mode is activated by pressing [ADD/KILL], the LED above it lights up. By pressing
[FLASH], any other active scene or programme is disabled.
In ‘Kill’ mode, the disabled programme is not stopped, but it can not be output.
9.11 Double Preset
1. To enter the "A Double Preset" mode, press [MODE SELECT].
2. In this mode, channel faders 1-12 as well as faders 13-24 control channels 1-12 .
3. With [MASTER A] the faders 1-12 are controlled, with [MASTER B] faders 13-24.
In this mode, no scene can be recorded.
Quick Start Guide for the main functions
DMX DC-1224
29
DMX controller
To Next Page
Loading...
Need help?
General