EasyManuals Logo

Botex DMX DC-1224 User Manual

Botex DMX DC-1224
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
7 Operating
7.1 Starting programming
7.1.1 Enabling programming
1. Keep [RECORD] pressed.
2. While holding down [RECORD], press the Flash buttons 1, 6, 6 and 8 in
sequence.
When you turn on the unit for the first time, the record code is 1, 6, 6
and 8. You can change the code to protect your programmes.
3. Release [RECORD] .
ð
The RECORD LED lights up.
Now you can start programming.
7.1.2 Protecting programmes
To protect your programmes, you can change the ‘Record’ code. To change the
Record code, proceed as follows:
1.
Activate the programming (
Ä
Chapter 7.1.1 ‘Enabling programming’
on page 16).
2. Keep [RECORD] and [EDIT] pressed simultaneously.
3.
The record code consists of a combination of four "Flash" buttons,
this number may not be exceeded or fallen below.
While holding down [RECORD] and [EDIT] , enter the new code using the flash
buttons.
4. Release [RECORD] and [EDIT] .
ð
The display shows ‘Cod’
5. Keep [RECORD] and [EDIT] pressed simultaneously.
Operating
16
DMX DC-1224
DMX controller

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Botex DMX DC-1224 and is the answer not in the manual?

Botex DMX DC-1224 Specifications

General IconGeneral
BrandBotex
ModelDMX DC-1224
CategoryController
LanguageEnglish