6
IMPORTANT: Always use ALKALINE batteries only.
Do not use heavy duty batteries.
DON’T MIX OLD AND NEW BATTERIES
Always remove the batteries for prolonged storage.
CHECK THE BATTERIES if your detector exhibits any of the following
symptoms:
●
1 The unit does not turn on.
●
2 Low speaker volume.
●
3
Unit beeps continuously or erratically.
The LOW BATTERY indicator will come on and stay on if the batteries
are discharge. You may notice erratic beeping if using with LOW
BATTERY illuminated.
IMPORTANT: Your Quick Silver metal detector requires two 9-Volt
ALKALINE batteries.
Follow these steps to install the batteries.
●
1 Carefully remove the battery compartment door by pressing the release
clip on the right side of the door.
●
2 Snap one battery
onto each of the
terminals and place
the batteries inside
the compartment.
Insert booth of the
batteries with
terminals facing
inward.
●
3
Replace the
compartment door
by carefully inserting
opposite side of clip
first. Then press
down on clip side
until battery door
snaps into place.
BATTERIES
Release
Clip
Both Batteries
terminals
facing in
To Next Page
Loading...
