7
Q
UICK-START DEMONSTRATION
I. Supplies Needed
• A Medium-Size Nail • A Quarter
• A Nickel • A Zinc Penny (dated after 1982)
II. Position the Detector
a. Place the detector on a
table, with the searchcoil
hanging over the edge.
(or better
, have a friend
hold the detector, with
the coil off the ground)
b. Keep the searchcoil away
from walls, floors, and
metal objects.
c. Remove watches, rings and other jewelry or metal objects from
hands and wrists.
d. Turn off appliances or lights that cause electromagnetic
interference.
e. Pivot the searchcoil back toward the detector body.
III. Power Up
Press the ON touchpad.
The detector will beep
several times and the
sensitivity setting will
be indicated on the
right of the display
. Two
illuminated segments
indicates 3/4 sensitivity.
IV. Wave each Object over
the searchcoil (
pass the flat side of the coins parallel to the coil)
a.Notice a different tone for each object.
Low Tone: Nail
Medium Tone: Nickel & Zinc Penny
High Tone: Quarter
b.
Motion is required. Objects must be in motion over the
searchcoil to be detected.
V. Press the TARGET REJECT
touchpad
To Next Page
Loading...
