M21/M26/M30
Necessary Operating Materials and Chemical Additives
Dear Customer,
In order to prevent any delays in the commissioning of your M21/M26/M30
drycleaning machine, we ask you to make sure that the following operating materials
and chemical additives are available.
- Solvent
The solvents used must have a flash point that is higher than the temperature stated
on the machine nameplate. The polycyclic aromatic compound content is not allowed
to exceed 0.01% by weight. The solvent must be heat-resistant under operating
conditions.
The solvent flash point must be checked every six months.
Total filling amount for the first filling: M21: approx. 445 l (117 US gal) *
M26: approx. 510 l (135 US gal) *
M30: approx. 565 l (150 US gal) *
Tank I: Minimum filling volume: M21: 110 l (29.3 US gal)
M26: 135 l (35.6 US gal)
M30: 155 l (40.9 US gal)
* Machine with 1 economy filter
- Chemical additives
The chemical additives used must be halogen-free and must have a flash point that is
higher than the temperature stated on the machine nameplate. The polycyclic aromatic
compound content is not allowed to exceed 0.01% by weight. The chemical additives
must be heat-resistant under operating conditions.
Depending on the equipment, the following should be available:
- Drycleaning detergent
- Waterproofing agent
- Pre- and post-spotting agents
To Next Page
Loading...
