19
6 Operation 6
6.2 Automatic Operation - Brief Instructions 6.2
Turn it on:
Open valves for water, steam and compressed air.
Set up the power supply.
Turn main switch "ON"
Display: BOEWE
Textile Cleaning
Machine type, for example: P 25
Deodorizing program "P34" is shown on display.
Press the "Start" button.
After the signal sounds, press the "Stop" button.
Loading:
Open the loading door,
load the cage according to the filling capacity,
close the loading door.
Erase the displayed, previous program
P34 by pressing C.
Select a program according to the overview.
Input the required program (e.g., program no. 2).
Start:
Press "Start ".
The program executes automatically.
During automatic and manual operation, the loading door is locked from the
start of the cycle until the end (signal).
A signal that sounds in intervals announces that the program has ended.
Stop: Press the "Stop" button.
Open the loading door and unload the garments.
Close the loading door.
If you repeat the same program, you only need to load the garments, close
the loading door and press the "Start" button.
If you do not restart the machine, the loading door locks after 1 minute.
You can unlock the door with the "⇑" button for up to 10 minutes. After 10
minutes, start deodorizing "P34".
Attention!
Shutdown the machine immediately if there are dangers of any
kind, such as if unbalances occur during the spinning cycle.
Machine shutdown, turn main switch "OFF" or activate emergency
shut down" switch.
P25/P30
To Next Page
Loading...
