Bowflex SelectTech 2080 - Safety Warning Labels and Serial Number; Specifications

4
Moving the Equipment
The fully assembled STB2080 Barbell assembly requires caution when being moved.
• 80-lbconguration—approximately117.3lbs(58.2kg)
• 120-lbconguration—approximately157.3lbs(76.3kg)
To move:
1. Remove the barbell assembly and weight plates from the base before moving the equipment.
The equpment may be moved by one or more persons depending on their physical abilities and capacities. Make sure that you and
others are all physically t and able to move the equipment safely.
Use proper safety precautions and lifting techniques. Bend your knees and elbows, keep your back straight and pull up equally with
both arms. Straighten your legs to lift.
Place the equipment on a clean, hard, level surface, free from unwanted material or other objects that may hamper your ability to
move freely. A rubber mat should be used below the equipment to protect your ooring.
2. Carefully replace the weight plates and barbell assembly in the base.
Leveling the Base
TheequipmentneedstobeleveledifyourworkoutareaisunevenoriftheBaseAssemblyisslightlyofftheoor.Toadjust:
1. Place the barbell assembly in your workout area.
2. Adjustthelevelersuntiltheyallcontacttheoor.
Do not adjust the levelers to such a height that they detach or unscrew from the machine. Injury to you or damage to the machine
can occur.
Makesurethebaseislevelandstablebeforeyouexercise.
MAINTENANCE
Equipment must be regularly examined for damage and repairs. The owner is responsible to make sure that regular maintenance
is done. Worn or damaged components must be replaced immediately or the equipment removed from service until the repair is
made. Only manufacturer supplied components can be used to maintain and repair the equipment.
If at any time the Warning labels become loose, unreadable or dislodged, replace the labels. If purchased in US/Canada, contact
Customer Service for replacement labels. If purchased outside US/Canada, contact your local distributor for them.
TheBowflex
™
SelectTech
™
Barbell is a very low maintenance product. However, there are steps that you should take to keep the product
performing and looking its very best.
1. Should your SelectTech
™
Barbell handle assembly, plates or base become soiled you may clean them with a cloth lightly dampened with
warm water and a small amount of mild soap. Wipe dry with a separate cloth.
2. The SelectTech
™
Barbell is internally lubricated and will not require further internal lubrication. The contact between weight plates and
selection mechanism is not lubricated but has naturally low friction. This generally will not require any lubrication. Should you feel it
necessary to lubricate the weight plates and/or selection mechanism, use only a 100% silicon lubricant.
Do not use any solvents, harsh detergents, chemicals or bleach on this product − doing so may damage the materials, resulting in
degradation of the product’s performance or strength.
Do not attempt to disassemble the barbell/curl bar handle or base assembly. These items are not designed to be user serviced.
Doing so will void the manufacturers warranty. Contact Customer Service (if inside US/Canada) or your local distributor (if outside
US/Canada).