32
5. Switch on your machine and start the belts at the slowest speed. Let the belts operate for approximately 15
seconds.
6. Switch off your machine.
7. Take care to clean up any excess lubricant from the Treadles. We also recommend a periodic inspection of the
Treadle surfaces below the belts. If the decks appear worn, contact a TreadClimber
®
Representative (refer to
the Contacts section of this manual).
To decrease the possibility of slipping, be sure the Treadle area is free from grease or oil. Clean off any
excess oil from the machine surfaces.
Walking Belt Alignment
The walking belts need to be adjusted if they are out of center enough to cause a rubbing or scraping sound.
Maintenance
To Next Page
Loading...
