39
Condition/Problem Things to Check Solution
Belts stop turning while in use Safety key Plug Safety Key into Console (See Safety Key
(Emergency Stop Procedures) in Features section).
Motor overload Unit may be overloaded and drawing too much
current, causing unit to shut power down to
protect motor. Consult belt lubrication schedule
to determine if belts need lubrication, check
walking belt tension, and restart unit.
Outlet Outlet may not have enough power available
for the machine due to other devices on same
circuit. Remove any devices from power circuit
and restart machine.
Console displays “C”, “S”, or “H”
with a number
Console Cycle power off and on to clear the error. If
issue recurs be sure to note the display code
and contact Customer Service for further as-
sistance.
Console displays “LUbE” code Belt lubrication Consult lubrication schedule and apply if neces-
sary. Push START button.
Troubleshooting
To Next Page
Loading...
