Bowflex Treadmill 22 - Troubleshooting

18
TROUBLESHOOTING
Service Mode Procedures
PROCEDURE 1: MCB COMMUNICATIONS TEST (I/O CABLE TEST):
1. Tap on the upper-right corner of the Console Display 10 times. The Console will display the “Advanced User Actions “ menu.
2. From the “Advanced User Actions “ menu, tap the INDIVIDUAL TESTS button. The Console will display a list of tests.
3. Tap on TEST-MCB_FW_VERSION. The Console will display the Firmware Version of the Motor Control Board (MCB).
4. Tap EXIT in the upper-right corner of the Display to exit.
PROCEDURE 2: CHECK FIRMWARE VERSION :
1. Tap on the upper-right corner of the Console Display 10 times. The Console will display the “Advanced User Actions “ menu.
2. From the “Advanced User Actions “ menu, tap the INDIVIDUAL TESTS button. The Console will display a list of tests.
3. Tap on TEST-CONSOLE_VERSION. The Console will display the Firmware Version.
4. Tap EXIT in the upper-right corner of the Display to exit.
PROCEDURE 3: RESET MACHINE (workout data will be lost):
1. Tap on the upper-right corner of the Console Display 10 times. The Console will display the “Advanced User Actions “ menu.
2. From the “Advanced User Actions “ menu, tap WIFI SETUP.
3. From the WIFI SETUP screen, tap on CLEAR PREFERENCES.
4. The Console will display a RESTART message. Unplug the power to the machine. The machine will reset when turned on.
PROCEDURE 4: CALIBRATE MCB:
1. Tap on the upper-right corner of the Console Display 10 times. The Console will display the “Advanced User Actions “ menu.
2. From the “Advanced User Actions “ menu, tap CALIBRATE in the upper right corner of the Console Display. The Console will shift to Calibrate
mode.
3. From the “Calibrate“ menu, tap CALIBRATE_MCB.
Be sure the area around the Treadmill is clear of all bystanders, children and pets. Be sure there is nothing on or under the
Walking Belt, or near the Treadmill.
4. The Console will display “CALIBRATE_MCB-USER CONFIRM”. Tap it, and the calibration procedure starts.
Note: The calibration procedure will begin by automatically moving the Walking Belt and adjusting the incline of the Walking Deck.
Be sure not to touch or allow anyone else to touch the machine while calibration is occurring.
5. When calibration is complete, the Console will display “CALIBRATE MCB - PASS”.
6. Tap EXIT in the upper-right corner of the Display to exit the Calibrate Mode.
7. Flip the power switch to OFF. Calibration is now complete for the machine.