Brady BBP12 - Page 40

BPP12 User Manual
40
Item
Description
Default
Darkness
Use this item to setup printing darkness. The available setting is
from 0 to 30, and the step is 1. You may need to adjust your
density based on selected media.
16
Print Speed
Use this item to setup print speed. The increase or decrease is 1
ips. Available setting is from 2 to 6.
4 (300dpi)
Tear Off
This item is used to fine tune media stop location. Available
setting value is from “+” to “-” or “0” to “9”.
+000
Print mode
This item is used to set the print mode. There are 3 modes as
below,
Printer
Mode
Description
Tear Off
Next label top of form is aligned to the
print head burn line location.
Peeler Off
Enable the label peel off mode.
Cutter
Enable the label cutter mode
Tear Off
Print Width
This item is used to set print width. The available value is from
“0” to “9”.
812 dot
List Fonts
This feature is used to print current printer available fonts list to
the label. The fonts stored in the printer’s DRAM, Flash or
optional memory card.
N/A
List Images
This feature is used to print current printer available images list
to the label. The images stored in the printer’s DRAM, Flash or
optional memory card.
N/A
List Formats
This feature is used to print current printer available formats list
to the label. The formats stored in the printer’s DRAM, Flash or
optional memory card.
N/A
List Setup
This feature is used to print current printer configuration to the
label.
N/A
Control Prefix
This feature is used to set control prefix character.
N/A
Format Prefix
This feature is used to set format prefix character.
N/A
Delimiter Char
This feature is used to set delimiter character.
N/A
Media Power Up
This option is used to set the action of the media when you turn
on the printer.
Selections
Description
Feed
Printer will advance one label
Calibration
Printer will calibration the sensor levels,
determine length and feed label
Length
Printer determine length and feed label
No Motion
Printer will not move media
No
Motion