Brady BBP12 - Maintenance and Cleaning Procedures; Print Head and Platen Roller Cleaning

BPP12 User Manual
55
CHAPTER 7 Maintenance
This session presents the cleaning tools and methods to maintain your printer.
1. Use one of following materials to clean the printer:
• Cotton swab (Head cleaner pen)
• Lint-free cloth
• Vacuum / Blower brush
• 100% ethanol
2. Clean the printer using the following process:
Printer Part
Method
Interval
Print Head
1. Always turn off the printer before cleaning
the print head.
2. Allow the print head to cool for a
minimum of one minute.
3. Use a cotton swab and 100% ethanol to
clean the print head surface.
Clean the print head when changing a
new label roll
Platen Roller
1. Turn the power off.
2. Rotate the platen roller and wipe it
thoroughly with 100% ethanol and a
cotton swab, or lint-free cloth.
Clean the platen roller when changing
a new label roll
Tear Bar/Peel Bar
Use the lint-free cloth with 100% ethanol to
wipe it.
As needed
Sensor
Compressed air or vacuum
Monthly
Exterior
Wipe it with water-dampened cloth
As needed
Interior
Brush or vacuum
As needed