What to do if my Brady Label Maker says 'Ribbon out. Replace ribbon and close inside printer cover. [58]'?
If your Brady Label Maker displays the error 'Ribbon out. Replace ribbon and close inside printer cover. [58]', it indicates that the ribbon ran out or broke during the print job. Replace the ribbon and restart the interrupted print job to continue printing.
What to do if my Brady BBP31 displays 'Printer Error. Media Jam. Print job canceled. Errors: 45, 54'?
If your Brady Label Maker shows 'Printer Error. Media Jam. Print job canceled. Errors: 45, 54', it means either the media is in the media guides but not detected by the leading edge sensor, or the media is detected by the sensor but not in the media guides, or the media is simply jammed. Reinstall the media and restart the print job to fix this.
What to do if my Brady BBP31 displays 'Error reading media memory cell. Reload or replace media. If error persists, contact technical support. Errors: 48, 49, 50, 51, 52'?
If your Brady Label Maker displays the error 'Error reading media memory cell. Reload or replace media. If error persists, contact technical support. Errors: 48, 49, 50, 51, 52', it means the printer cannot read the media memory cell because the code is incorrect, the cell cannot be read, the data in the cell is corrupted, the cell is the wrong version or the media counter shows no media remaining. You should replace the media.
What to do if my Brady Label Maker says 'Printer too warm. Print job was canceled. Error: 18'?
If your Brady Label Maker displays 'Printer too warm. Print job was canceled. Error: 18', it means the printhead has reached its maximum operating temperature. Allow the printhead to cool down for about 10 minutes before restarting the print job.
What to do if my Brady BBP31 says 'Printer too cold. Print job canceled. Error: 20'?
If your Brady Label Maker displays 'Printer too cold. Print job canceled. Error: 20', it means the printhead hasn't reached the required operating temperature. The normal operating range is between 50-104° F (10-40° C). Allow the printer to warm up to the operating temperature before printing.
What to do if my Brady BBP31 Label Maker displays 'Printer Error Error: 85'?
If your Brady Label Maker displays 'Printer Error Error: 85', the printer has advanced die-cut media but cannot detect the notch. This could be due to a dirty or failing sensor. Check and clear the media path, then reload the media.
General| Print Resolution | 300 dpi |
|---|---|
| Display | Color touchscreen |
| Cutter | Automatic |
| Power Source | AC power |
| Print Technology | Thermal transfer |
| Max Label Width | 4 inches |
| Connectivity | USB |
| Memory | 64 MB |
| Supported Materials | polyester |
| Dimensions | 9.5 x 7.5 x 5.5 inches |
| Maximum Label Length | Infinite (continuous) |
To Next Page
