Braeburn 1025NC - Attach Thermostat to Sub-Base

Factory Setting
Switch Default Options Comments
6
F/C F
 HE/HG HG
Set Installer Switches
4
F Selectforfahrenheittemperaturescale
 C Selectforcelsiustemperaturescale
 HG Selectforgasheatorhydronicsystems
  withoutfan
 HE Selectforelectricheatorhydronic
  systemswithfan
Attach Thermostat to Sub-Base
5
1.Lineupthethermostatbodywiththesub-base.
2.Carefullypushthethermostatbodyagainstthesub-baseuntilitsnaps
 intoplace.
3.Insertquickreferencecardintoslotontopofthermostat.
NOTE: The reset button should be pressed after making any changes to the
installer switches.
UP UP