Need help?Do you have a question about the BRAND dispensette and is the answer not in the manual?
General| Material | PTFE |
|---|---|
| Autoclavable | Yes |
| Sterilization | Autoclave |
| Viscosity Limit | Up to 500 mPa·s |
| Density Limit | Up to 2.2 g/cm3 |
| Pressure Limit | Up to 1 bar |
| Operating Temperature | 5°C to 40°C |
Physical limits for dispensing liquids, including temperature, vapor pressure, and viscosity.
Conditions affecting dispensing, such as deposits, static charge, and general laboratory use.
Lists specific liquids that should not be used with Dispensette III or Organic models.
Details suitable liquids for Dispensette III and Organic models.
Steps for assembling the dispenser and its components.
Attaching the filling tube and recirculation tube to the dispenser.
Securing the dispenser onto a reagent bottle.
Accessory for priming without medium loss.
Accessory for serial dispensing.
Procedures for cleaning and replacing dispenser valves.
Procedure for returning instruments for repair.
To Next Page
