What to do if there is liquid in suction system of BRAND micro?
If you find liquid in the suction system of your BRAND Laboratory Equipment, it's likely because the thumb wheel was turned too quickly. To resolve this, clean or disinfect the suction system. If cleaning doesn't suffice, replace the suction system.
How to fix ejector key if it does not work on BRAND micro Laboratory Equipment?
If the ejector key on your BRAND Laboratory Equipment isn't working, it could be improperly positioned. To fix this, remove the clip, hold the instrument loosely, and quickly press down the ejector key. Then, slide the clip back on.
What to do if pipette is ejected from the adapter of BRAND micro Laboratory Equipment?
If the pipette is being ejected from the adapter of your BRAND Laboratory Equipment, the adapter may be wet or greasy. Try cleaning or disinfecting the suction system and ensure it's completely dry. If the issue persists, you may need to replace the suction system.
How to remove broken pipette in the adapter of BRAND micro?
If you have a broken pipette in the adapter of your BRAND Laboratory Equipment, it's likely because the pipette was damaged or forced into the adapter. Carefully remove the glass splinters using forceps. If necessary, replace the adapter.
What to do if there is liquid in the suction system of BRAND Laboratory Equipment?
If liquid gets into the suction system of your BRAND Laboratory Equipment due to turning the adjustment wheel too quickly, you should clean or disinfect the suction system. If that doesn't resolve the issue, consider replacing it.
Why is the suction system of BRAND micro not working or pipette dripping?
If the suction system of your BRAND Laboratory Equipment is damaged, causing it to not work or the pipette to drip, the suction system should be replaced.
How to remove a broken pipette from the adapter in BRAND micro?
If a pipette breaks off in the adapter of your BRAND Laboratory Equipment because it was damaged or pushed in with too much force, remove the glass fragments with tweezers. If necessary, replace the adapter.
Why BRAND Laboratory Equipment does not draw in liquid or the pipette drips?
If your BRAND Laboratory Equipment isn't drawing in liquid or the pipette drips, it might be due to a damaged suction system. In this case, you should replace the suction system.
What to do if the ejector button does not work on BRAND Laboratory Equipment?
If the ejector button on your BRAND Laboratory Equipment isn't working because it's not positioned properly, remove the clip. Hold the instrument loosely and briefly press the ejector button, then slide the clip back on.
What to do if the pipette is ejected from the adapter of BRAND Laboratory Equipment?
If the pipette is ejected from the adapter of your BRAND Laboratory Equipment because the adapter is too moist or greasy, clean or disinfect the suction system and let it dry. If the issue persists, replace the adapter.
Instructions on how to securely fit pipettes to the controller without damage.
Guide to setting the desired volume using the thumb wheel for different pipette sizes.
Step-by-step process for aspirating liquids, emphasizing contamination prevention.
Procedures for dispensing liquids accurately, including specific methods for 'In' calibrated pipettes.
General| Brand | BRAND |
|---|---|
| Model | micro |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
