8
Installation
InstallationInstallation
CHOICE OF LOCATION AND BUILDING IN
Centre the oven in the unit so as to ensure
a minimum distance of 10 mm between the
appliance and the surrounding unit. The
material of the unit supporting the appliance
must be heat-resistant (or covered with a heat-
resistant material).
Drill a 2 mm diameter hole in the cabinet panel
to avoid splitting the wood.
For greater stability, attach the oven to the
unit with 2 screws through the holes provided
on the side panels (fig. C).
Warning:
Installation should only be performed by
installers and qualied technicians.
WARNING
This appliance must be installed more than
850 mm up o the ground. This appliance
may be installed in a cabinet column, as in-
dicated on the installation diagram (g. A).
Caution: if the back of the cabinet is open,
the space between the wall and the surface
on which the oven rests must be no more
than 70 mm* (g. B).
A
B
C
To Next Page
Loading...
