Braun 7 series Cleaning Instructions

5 Braun Series7 Electric Shaver Cleaning Instructions
Cleaning the Shaver Using the Clean and Renew Station
To clean the shaving head mechanisms using the Clean and Renew Station:
1. Insert the smaller plug of the AC power cord into the AC power cord outlet on the
back side of the Clean and Renew Station (see Figure 9) and the larger plug into a
standard AC wall outlet (see Figure 10).
Figure 9: Small AC Plug Figure 10: Large AC Plug
2. Insert the Braun Series7 shaver upside down into the Clean and Renew reservoir
opening at the top of the station.
Note: If the shaver is properly seated inside the reservoir cavity, one of three cleaning
level lights illuminates on the right side of the Station. The proper seating of the
shaver inside the Clean and Renew Station is displayed in Figure 11 below.
Figure 11: Shaver Cleaning Configuration

Braun 7 series Specifications

General

Sonic Technology	Yes
Wet & Dry	Yes
Charging Time	1 Hour
Running Time	50 minutes
Travel Lock	Yes
Precision Trimmer	Yes
Waterproof	Yes
Series	7
Shaver Type	Foil Shaver
Battery Type	Li-Ion
Quick Charge	5 minutes for one shave
Display	Yes
Cleaning Station	Clean & Charge Station (depending on the model)