Page 37
Lift
Disposal
Procedure
No lift components contain unacceptable amounts of
lead, cadmium, mercury, or hexavalent chromium.
2000-53-EC
Disassembly and Disposal Guidelines
1. Lower platform to ground.
2. Open pump module manual relief valve.
3. Disconnect power from lift.
4. Capture and recycle hydraulic uid.
5. Disassemble lift and recycle components.
Refer to exploded views in appropriate service
manual.
Maintenance and Lubrication Schedule
Apply Door-Ease or replace if needed.
See Lubrication Diagram.
Resecure or replace if needed.
Resecure, repair or replace if needed.
Check to see that the lift is securely
anchored to the vehicle and there are
no loose bolts, broken welds, or stress
fractures.
Replace decals if worn, missing, or
illegible. Replace antiskid if worn or
missing.
Inspect saddle bearings (2) / buttons (4)
Inspect vertical arms and plastic
covers
Inspect power cable
Mounting
Decals and Antiskid
4500
Cycles
Repeat all previously listed inspection,
lubrication and maintenance procedures at
750 cycle intervals.
Consecutive
750 Cycle
Intervals
To Next Page
Loading...
Need help?
General
